15. Do not use this machine for the grounding of the welding neutral line:
16. Do not use the machine in any foreseeable emergency situation.
17. The level must be adjusted before use, otherwise it cannot be used;
18. The lift is not allowed to move or adjust the base during work:
19. It is not allowed to climb or stand on the guardrail of the manned platform;
20. It should be used on a solid and flat ground, never on temporarily erected benches and trucks
(Trucks, vans, useless cars), on beds or on extended surfaces:
21. When the elevator is working, no load is allowed to touch the side to prevent the accident from disappearing;
22. If the ground is soft and soft under the feet, make a solid skid and adjust it properly;
23. When the elevator is working, no one is allowed to stand under the manned frame:
24. The driver must carefully check the electrical system, hydraulic system and mechanical system of the platform before working every day.
Check whether the mechanical system is normal, and test the platform with no load for several times to check whether there is any fault or abnormality.
If the phenomenon occurs, it is also necessary to pay attention to whether there is a significant abnormal difference in the accuracy of the landing platform on the platform.
25. The driver closes the movable doors at both ends of the guardrail and locks them before starting the work.
Work under the condition that the movable door of the guardrail is open. It can be used in special situations when the platform is running
The emergency stop switch stops the platform, but in normal operation, it is forbidden to use the emergency stop switch to stop.
26. The driver should be responsible for supervising that the items transported by the platform are distributed as evenly as possible on the platform to prevent
partial load, and prohibit overload operation. The platform is not allowed to carry and transport dangerous items such as flammable and explosive
And it is forbidden to climb and artificially rock when ascending.
27. Drivers are strictly prohibited from leaving their posts and wiping, lubricating or repairing the platform while working on the platform.
management work. When the work is completed, the driver should cut off the power supply and lock the control panel before leaving the post.
And fill in the shift record.
28. When the platform fails or fails to work properly, the maintenance personnel should be notified immediately for repair.
If it is found that there is a danger or may cause a personal and mechanical accident, it should be stopped immediately and the machine room should be cut off.
The main power supply should be reported to the management department, and can only be used after repair and specific inspection.
