Reach truck is a very popular kind of forklift now. It has high flexibility, large load, high horsepower, easy to operate and easy to learn, and it is much easier to repair and maintain than other forklifts. Even so, it can have glitches. If there is a problem with the mast and the fork, it will bring a lot of inconvenience to our work. In order to save costs and put the reach truck into work as soon as possible, they will choose to disassemble and repair it by themselves. But it is easy to disassemble and difficult to install. How to assemble the mast and fork of the reach truck? Electric forklift manufacturers come to talk to you.
First of all, pay attention to the front and rear clearances between the inner and outer masts of the reach truck. When selecting rollers, it is necessary to select rollers with a gap of less than 1mm for assembly. When assembling, after determining the appropriate clearance, operate the lifting handle to let the inner mast run up and down. Electric forklift manufacturers tell everyone that to ensure that the mast runs smoothly, the rollers can rotate freely, smoothly and evenly.
Then, we must pay attention to the left and right gaps between the inner and outer masts of the reach truck. According to the required size, adjust the installation position of the lateral rollers by increasing or decreasing the gasket to ensure that the gap between the rollers and the inner and outer walls of the channel steel of the inner and outer masts reaches the standard. When the inner mast is at the highest position, the gap is 0.1~1.0mm. The electric forklift manufacturer tells everyone that when the inner mast is at the lowest position, the clearance is 0.1~1.0mm.
Then take a look at the left and right clearance of the fork frame of the reach truck. The adjustment method of the left and right clearance of the fork frame is the same as that of the inner and outer masts, except that the standard clearance value is 0.1~1.0mm. After adjustment, make sure that the lifting fork and inner mast move smoothly. Electric forklift manufacturers tell everyone that if the inner and outer masts cannot fall freely through the forks when lowered from the maximum height, they must be readjusted.
The above is the method of assembling and adjusting the mast and fork frame of the reach truck. During installation, everyone must pay attention to the size of the gap between the rollers and the inner and outer masts and forks, which determines whether the inner and outer masts and forks can move normally. After the final installation, be sure to check and adjust.
