Long-term use of the Manual forklift can cause wear and tear. So, what are the ways to maintain the manual forklift wear? Let's take a look at it! I hope to help everyone.It is necessary to regularly grind the lubricant between the manual forklift link pins to reduce the degree of wear between the parts and reduce the noise, which can prevent the occurrence of safety accidents. Remove and disassemble the Manual forklift drop valve, blow the plunger with compressed air, load it, and reattach it. Check all hydraulic lines and fittings. The pipe must not be damaged, the joints should not be loose, and all joints must be tightened.
The oil quality and oil level of the hydraulic oil. The manual forklift rises all the way. In this position, the hydraulic floor should be 40 to 50 mm above the bottom of the box. If the hydraulic oil is found to be dark, sticky or has gravel and other foreign matter, it should be replaced in time. Regularly check hydraulic manual forklift rollers, intermediate shafts and bearings, cylinder pins and bearings, boom hinges and bearings for wear. Between any part of the hydraulic system, the pressure must first be relieved to prevent the pressure oil from escaping, and the Manual forklift table slips.Do not arbitrarily adjust the relief valve. Each component in the hydraulic manual forklift system operates under defined pressure. Any adjustment of the relief valve may cause the hydraulic system to malfunction. When inspecting under the Manual forklift work platform, the Manual forklift work platform must be hung and supported to prevent the Manual forklift from falling.
Non-professional staff are not allowed to disassemble electrical appliances at will to avoid electric shock or misconnection. Manual forklift has been inspected and debugged before leaving the factory. The technical specifications meet the design requirements. When using, only the power supply is required, and the hydraulic and electrical systems do not need to be adjusted. Dispose of the hydraulic oil and discard it. Tighten the joint and drain the oil filter. After washing, clean it with compressed air, then put it back into the tank and connect the pipe. Pay attention to the noise generated by the manual forklift when it rises and falls. If the noise is too loud, immediately disconnect the power supply and check the noise. Check the Manual forklift regularly.
