1. Park the forklift on a flat, hard road, turn off the engine, and leave the forklift in a no-load state.
2. The fork is lowered to the ground, and the wheels are stopped by the parking brake device. If the driving tire is replaced, the jack is supported at the front side of the frame. If the steering tire is replaced, the jack is supported in the center of the rear bracket of the rear axle.
3. Use a jack to slightly lift the forklift so that the tire is still in contact with the ground; first unscrew the bolt that fixes the inflation tube, remove the clip, and then loosen the hub nut.
4. Use a jack to fully support the car, unscrew the wheel nut, and remove the tire.
5. The installation order is the reverse of the removal order. When installing the hub nut, the tightening torque must reach the specified value.
